How does rotary actuator hydraulic works

The networked world has changed our lives, but it has also changed the way we produce. The automation, informatization, networking and intelligent construction of enterprises is a priority in the business world, and the adoption of latest intelligent production instrumentality could be a necessity for realizing automatic production, establishing automatic production lines, building information factories and realizing intelligent producing. The rotary actuator hydraulic is an important part of modern manufacturing. These devices facilitate smooth movement and control while minimally affecting the environment. They are commonly used on a wide range of high-precision applications including vision systems, car manufacturing facilities and medical equipment. This article will introduce you to rotary actuator hydraulics.

Here is that the content:

• l  How rotary actuator hydraulic works

• l  Precautions for rotary actuator hydraulic

How rotary actuator hydraulic works

The rotary actuator hydraulic is driven by the hydraulic system. After the high-pressure oil supplied by the hydraulic system enters the upper cavity of the hydraulic cylinder, it pushes the piston and drives the auxiliary screw down. Because the auxiliary nut is fixed on the hydraulic cylinder support and cannot rotate and move, the auxiliary screw makes downward spiral movement. The lead of the auxiliary screw and the main screw are the same, and they are connected by a cross groove coupling, so the auxiliary screw drives the flywheel and the main screw to make synchronous downward spiral movement, so that the flywheel can obtain energy, and the slider goes down, and the forging is punched through the die satin. When the high-pressure oil enters the lower cavity of the hydraulic cylinder, the piston is pushed to drive the auxiliary screw and the main screw to make upward spiral motion, so that the slide block lifts the return stroke. When the supply of high-pressure oil to the upper and lower chambers of the hydraulic cylinder stops and the oil discharge valve of the lower chamber closes, the slide block is stationary and stops at the set position.

Precautions for rotary actuator hydraulic

1. The position of the rotary actuator hydraulic, as far as possible to make the braking force and driving force on the shaft balance.

2. The air outlet of the rotary actuator hydraulic should be located above the brake body to facilitate the air discharge.

3. The position of supercharger or oil pressure source should be higher than the rotary actuator hydraulic, and the closer to the rotary actuator hydraulic, the better.

4. A space of about 70mm*70mm should be reserved at the fixed end of the rotary actuator hydraulic, so as to facilitate the replacement of the incoming piece from the inside.

5. The sealed design should be avoided, so that the air can circulate smoothly, and the brake disc has better heat dissipation effect.

6. The incoming disc should be in full contact with the brake disc.

7. The brake disc should be placed in the center of the brake chuck, deviation should be less than 0.2 mm..

8. The amplitude of twitching disc should be controlled within 0.1mm.

Rotary actuator hydraulic installation, in which the disc thickness and diameter are obviously different. Leading to a certain difference in their weight.

Changsha Chiyu Hydraulic instrumentality Co., Ltd. is a company that develops and manufactures rotary actuators. The company was founded in 2019 in Changsha, the capital of China, with an expert research and development team and a repair network throughout the country. The 5,000 sqm facility in Weihai has been divided into all departments to allow for complete production cycle from mechanical process to mounting and final testing. As such, it is a reliable company with a gentle stream of quality products, looking forward to your visit!