Basic information of hydraulic rotary actuator

Changsha Chiyu hydraulic equipment Co., Ltd.'s expertise, reliability, friendliness and quick response ability have benefited them a lot. By continuously improving processes and optimizing costs, they ensure that their economic strength, technical competitiveness and growing service scope are applicable to both existing and new customers. The following is the Changsha Chiyu hydraulic equipment Co., Ltd. hydraulic rotary actuator introduced to you, it will follow the development trend of the industry, take the drive and control as its main business, and strive to provide qualified cutting-edge high-precision products for customers as its mission, so as to build us into a professional enterprise recognized and respected by peers.

Here is that the content:

• l  The brief introduction to hydraulic rotary actuator

• l  Precautions for hydraulic rotary actuator

The brief introduction to hydraulic rotary actuator

hydraulic rotary actuator, is the so-called brake. It is a mechanical part that stops or slows down the moving parts in machinery. Commonly known as brake, brake. Brake is mainly composed of frame, brake parts and control devices. Some brakes are also equipped with automatic adjustment devices for the clearance of brake parts. In order to reduce the braking torque and structural dimension, the brake is usually installed on the high-speed shaft of the equipment, but the large equipment with high safety requirements (such as mine hoists and elevators, etc.) should be installed on the low-speed shaft near the working part of the equipment. Some brakes have been standardized and serialized, and are manufactured by professional factories for selection.

Precautions for hydraulic rotary actuator

1, The position of the device brake, as far as possible to make the braking force and driving force on the shaft balance.

2. The air outlet of the brake should be located above the brake body to facilitate the air discharge.

3. The position of supercharger or oil pressure source should be higher than the brake, and the closer to the brake, the better.

4. A space of about 70mm*70mm should be reserved at the fixed end of the brake, so as to facilitate the replacement of the incoming piece from the inside.

5. The sealed design should be avoided, so that the air can circulate smoothly, and the brake disc has better heat dissipation effect.

6. The incoming disc should be in full contact with the brake disc.

7, the brake disc should be placed in the center of the brake chuck, deviation should be less than 0.2 mm..

8. The amplitude of twitching disc should be controlled within 0.1mm.

Changsha Chiyu hydraulic equipment Co., Ltd. maintains a trust and cooperation relationship with its customers. They listen, analyze and understand your needs. ECKART can customize the right solution according to your needs. This enables them to provide the highest customer value with excellent quality. Through their services and support services, they provide first-class and comfortable services from the time of delivery. And our products are also in the first line of quality, and we always guarantee that you will be very satisfied with ours.